Netstat -an (this will combined both of the above) Netstat -n (this will show you all the open connection with IP addresses) Netstat -a (this will show you all the listening ports and connection with DNS names)
#COMMAND PROMPT COMMANDS FOR HACKING CODE#
This command code will show you connection stats of all the available networks. Ipconfig /renew (this will renew your iP) Ipconfig /release (this will release your IP) This command will give all that info but for all networks, you might have it.Īlso, in case you have a dynamic IP and want to change it, then type… This command will show you a lot of useful things like your IP, Gateway, DNS in use, etc.
It is pretty simple yet cool cmd commands to look like a hacker This command will show you the routing table, gateway, interface and metric. You can find out if anyone has done arp poisoning in your LAN using this command. Next up on the CMD hack code list, it will show you the ARP table. Tracert (is the website you don’t know the IP) This command is really helpful if you know the route a packet takes before it goes to the target box.Ĭode: tracert x.x.x.x (x is the IP address) This command will give you the hops that a packet will travel to reach its final destination. You can check the tutorial here for sending a spoofed email.
Simple, isn’t it? You can send a spoofed email to your friends using the IP address of the mail server. You can use whatever server you want and if it is listed on DNS, then you get the IP. This hacking command will give you the mail server IP of.
0 kommentar(er)
